Oki Microline 8480FB User Manual page 42

Auto Align Detect
Detects and corrects paper skew when manual feed through the
platform is being used with Auto Align enabled [the default].
Available settings: Valid Level 1, Valid Level 2 [the default], or
Invalid.
Change to Valid Level 1 if you wish the detection to be more
precise.
Change to Invalid if you are experiencing difficulty getting forms to
load into the printer when using preprinted forms with anomalies
at the top such as a large dark area on one side or a cutout. Such
types of forms defeat the skew sensor.
Auto Align (POW)
Note This setting interacts with the other "Align" items in the
Group Manual Feed group (see page 36).
Sets the alignment method (skew adjustment) engaged for
manual feed from the platform when the printer is turned on.
Note This setting does not affect the printer when it initializes in
response to an I-Prime signal.
Available settings: Align 1, Align 2, Align 3, Align 4, or
SelectAutoAlign [the default].
• Select Auto Align [the default]: Skew adjustment is set by
Auto Align in the Manual Feed group. (see page 41).
• Align x (x = 1, 2, 3, or4): Skew adjustment is set by the
corresponding Alignx Pos.Adj in the Manual Feed group (see
page 41).
Auto CR
IBM emulation only.
The default is No. If you want the printer to automatically add a
carriage return when a Line Feed is received at the end of a line,
change the setting to Yes.
Form Unusable with Auto Align.bmp
Microline 8480FB User's Guide
• 42