Attaching The Enclosure - Panasonic WV-SFN130 Installation Manual

■ Ceiling
Horizontal : -20° to +20°
Vertical : -20 ° to 0 ° (right under)
to +90 ° (right beside)
3
Rotate the lens adjuster (accessory) to adjust the focus of the lens.
Note:
• When the focus is difficult to adjust, set the [Zoom] button on the "Live" page to [x2].

Attaching the enclosure.

■
1
Remove the packaging from the rear of the dome cover, and then attach the enclosure to the camera with
2 enclosure fixing screws (M3)
IMPORTANT:
• When attaching the enclosure the focus may be slightly disturbed. If this occurs, remove the
enclosure and make the necessary adjustments.
• Before attaching the enclosure, make sure that the subject is present.
• Securely tighten all the fixing screws (x2) of enclosure. Otherwise, the enclosure of the camera
dropping may result in injury.
(Recommended tightening torque: 0.4 N·m {0.3 lbf·ft})
■
Ceiling
Enclosure
fixing
screws
2
Close the screw cover.
3
Remove the cover film from outside of the dome cover.
IMPORTANT:
• Remove the cover film attached to the domecover after the camera installation is completed.
After removing the cover film, do not touch the dome cover with your hands.
. (Recommended tightening torque: 0.4 N·m {0.3 lbf·ft})
■
Wall
Enclosure
fixing screws
■ Wall
Vertical : -20 ° to 0 ° (right beside)
to +90 ° (right under)
Horizontal : -90° to +90°
25