Planet Networking & Communication FRT-415N User Manual page 37

IP Protocol
PPP Settings
User Name
Password
Type
Idle Time (min)
WAN IP Settings
Type
Local IP Address
Remote IP Address
Netmask
Default Route
Unnumbered
WAN Interfaces Table
You can select IPv4, IPv4/IPv6 or IPv6.
Enter the correct user name for PPP dial-up, which is provided by your
ISP.
Enter the correct password for PPP dial-up, which is provided by your
ISP.
You can choose Continuous, Connect on Demand, or Manual.
To set the type to Connect on Demand, you need to enter the idle
timeout time. Within the preset minutes, if the router does not detect the
flow of the user continuously, the router automatically disconnects the
PPPoE connection.
You can choose Fixed IP or DHCP.
 To select Fixed IP, you should enter the local IP address, remote IP
address and subnet mask.
 To select DHCP, the router is a DHCP client and the WAN IP
address is assigned by the remote DHCP server.
Enter the IP address of WAN interface provided by your ISP.
Enter the default gateway of WAN interface provided by your ISP.
Enter the subnet mask of the local IP address.
Select Disable, Enable or Auto. The default setting is Enable.
Select this checkbox to enable IP unnumbered function.
This table shows the existing WAN settings. The maximum item of this
table is eight.
37
User Manual of FRT-415N