Ohlins SUPERBIKE FG 570 Owner's Manual page 13

6.
Install the piston and the shims on the
compression valve. Tighten the 8 mm nut
with a torque of 7 Nm. Check the piston
ring and the O-rings for damages. Replace
if necessary.
Install the compression valve assembly into
the valve housing. Tighten to 20 Nm.
Compression valve assembly:
7.
Apply some front fork oil (1311-01) to the
inner tube surface and carefully mount the
outer tube (slide it completely down).
WARNING!
!
Be careful not to damage the fork seal!
8.
Fill up with Öhlins front fork oil (1311-01) all
the way to the edge of the reservoir. Con-
tinue to fill until the oil level is the same in
both the reservoir and in the cylinder tube.
9.
Push the gas piston, with teflon band
and O-ring fitted, to the reservoir bottom
without allowing it to be pressed back over
the circlip groove, make sure that there is
no air between the piston and the oil. Use
tool 720-02.
Close the compression adjuster.
6
8 mm Nut,
7Nm
Comp. valve assembly,
20 Nm
7
9
Tool 720-02
8
13