Assembly Of The Forks - Ohlins FG 470 Owner's Manual

Assembly of the forks

1.
Use Tool 786-07 to refit the reservoir tube.
Tighten to 45 Nm.
2.
Use Tool 786-05 to refit the inner tube of
the fork leg. Tighten to 80 Nm.
3.
Put the outer tube standing up on a soft
surface, seal side up. Fit the bushings
from the seal side of the outer leg. Install
first the upper bushing then the lower one.
Use installing sleeve (1759-08), guide ring
(1758-04) and attachment bar (1757-01)
when installing the upper bushing. Ap-
ply Loctite 601 on the seat position of the
upper bushing, use a long brush. Tap the
attachment bar until it reaches the correct
position (stop against a shoulder).
4.
When the upper bushing is in position, the
lower bushing is to be installed the same
way. Apply some red grease (146-01) to
the bushing before installation.
5.
Apply a thin layer of Öhlins red grease
(146-01) to the washer and to the sealing
surfaces of the fork seal. Install the seal
and the washer in the outer tube. Fit the
circlip into the groove.
NOTE!
It is important to use the correct grease in
order to achieve optimum fork function.
12
1
Tool 786-07
3
Long brush
Loctite 601
Outer tube
4
2
Tool 786-05
Lower bushing
Upper bushing
Guide ring
(1758-04)
Attachment bar
(1757-02)
Installing sleeve
(1759-08)
Rubber mat
5
Circlip
Washer
Seal