Table of Contents
Advertisement
Section 3 - Configuration
Network Setup lets you configure how you connect the NVR to the Internet or local network.
DHCP:
Select this connection if you have a DHCP server running on your network
and would like a dynamic IP address to be automatically updated to your
NVR.
Static IP:
You may obtain a static or fixed IP address and other network information
from your network administrator. A static IP address will simplify access to
your NVR in the future.
IP Address:
Enter the fixed IP address of the NVR and the port that is used to access the
web interface.
Subnet Mask:
Set this to match the subnet mask of the provided IP address. The default
value 255.255.255.
Gateway:
Set this to the default gateway on your router or local subnet for proper network routing.
DNS1:
Primary domain name server that translates names to IP addresses.
DNS2:
Secondary domain name server to back up the primary domain name server.
Enable
Enable this setting if your ISP is using PPPoE. You may already have a Username and Password provided by your ISP, or you may
PPPoE:
need to contact your ISP. The connection status will be determined automatically by the system.
DHCP Server:
Enable or disable the DHCP server. If your network doesn't have a DHCP server, enable this feature for easier local network setup.
You can specify the IP address range and lease time that DHCP uses to provide IP addresses to clients.
Enable Bonjour:
Enable the Bonjour service to allow users to discover the DNR-2020-04P with Apple devices.
D-Link DNR-2020-04P User Manual
Setup
Network
Network Setup
26
Advertisement
Table of Contents
