Table of Contents
Advertisement
Section 3 - Configuration
This page lets you configure what to do when an event is triggered by a
camera, such as when motion is detected. The NVR can then perform an
action, such as sending an e-mail notification.
For Camera Event Settings and System Event Settings:
Step 1: Select an event to listen for:
Connection
An action is executed when connection is lost.
Lost:
Motion
An action is executed when motion is detected.
Detected:
Passive
An action is executed when the PIR sensor is activated.
Infrared:
Digital Input:
An action is executed when the signal voltage is above or below a
specific threshold.
Sound
Detection:
An action is executed when the camera microphone detects audio.
Hard Disk
When the Overwrite function is not enabled, the NVR will stop
Space Full:
recording when the HDD is full and will send an alert.
Hard Disk
An alert will be sent if there is an error with the hard disk.
Error:
Fan Error:
An alert will be sent if there is a fan error.
Network
An action is executed when the NVR is disconnected from its
Disconnected:
network.
D-Link DNR-2020-04P User Manual
Event Settings
39
Advertisement
Table of Contents
