Advertisement
Quick Links
Planar Systems, Inc.
1195 NW Compton Drive
Beaverton, OR 97006-1992
+1 (866) PLANAR1
www.planarhometheater.com
The PD8130/PD8150 is shipped with the standard (1.85:1 to 2.40:1) projection
lens pre-installed. If your installation requires the optional short-throw (1.56:1 to
1.86:1) lens, proceed as follows to remove the standard lens and replace it with
the short-throw lens.
1. Using a Phillips screwdriver,
remove the two screws holding
the projector front cover in place.
2. Gently pull the cover away from
the projector at each side to
detach it.
3. Remove the cover and set it aside.
020-0960-00 Rev. B
PD8130/PD8150 Short-Throw
1.
1
Lens
Part Number 997-5351-00
Installation Instructions
Advertisement
Related Manuals for Planar PD8130
Summary of Contents for Planar PD8130
- Page 1 +1 (866) PLANAR1 www.planarhometheater.com The PD8130/PD8150 is shipped with the standard (1.85:1 to 2.40:1) projection lens pre-installed. If your installation requires the optional short-throw (1.56:1 to 1.86:1) lens, proceed as follows to remove the standard lens and replace it with the short-throw lens.
- Page 2 PD8130/PD8150 Short-Throw Lens Removing the Stray Light 4. Remove the center top and center bottom Phillips screws securing the left ➤ Shield and right halves of the light shield to each other. 5. Remove the two Phillips screws holding the left half of the shield in place.
- Page 3 7. Remove the foam shield around the front of the lens and set it aside. (You Removing the Standard will install it on the replacement lens later.) Lens 8. Remove the two (2), black plastic retaining clips on either side of the lens. Each clip is held in place with two (2), captive Phillips screws.
- Page 4 PD8130/PD8150 Short-Throw Lens Installing the Short-Throw 10. Remove the vertical lens shift adjuster from the ➤ Vertical Lens and Re-Assembling top of the lens assembly that you just removed. Lens Shift the Projector Install it at the same location on the Adjuster replacement lens assembly.