Instructions To Customer - Panasonic KX-TG6461AL Operating Instructions Manual

Useful Information

Instructions to customer

Installation
Attached to this telephone is an approval label. This label is evidence that it is a "Permitted Attachment"
which has been authorised to be connected to your telephone service.
Conditions relating to connection and operation of this Permitted Attachment are contained in
Telecommunications General By-Law 220 (5).
You are authorised to install this Permitted Attachment yourself by plugging it into the line socket of any
regular telephone. You may connect it in place of your existing telephone or to any spare telephone
socket installed in your premises.
To disconnect your existing telephone you must first remove its plug from the line socket. You can then
insert the plug of your Permitted Attachment into the socket and use your equipment.
If the plug of your existing telephone cannot be readily removed, you will have to remove the screw
securing it. To do this proceed as follows:
1
Loosen screw "A" sufficiently to remove the socket cover. (See Fig. 1.)
2
Remove screw "B" and withdraw the plug. (See Fig. 2.)
3
Replace screw "B". (See Fig. 3.) Ensure that it screws completely into the socket recess. (If the screw
is too long, increase the hole depth or replace the screw with one 5 mm shorter.)
4
Replace socket cover and tighten screw "A". (See Fig. 4.)
SCREW "A"
If you are satisfied with the operation of your telephone service after plugging in your Permitted
Attachment, your installation is completed.
You will be unable to connect this Permitted Attachment if your telephone service consists only of a wall
phone or an old style telephone which is not connected by means of a modern plug and socket. In such
cases a new socket will need to be installed.
46
SOCKET PLUG
TELEPHONE CORD
Fig. 1
(
Connect to the PLUG
as shown in Fig. 1.
SCREW
"B"
Fig. 3
SCREW
"B"
Fig. 2
)
SCREW "A"
SOCKET
Fig. 4