Troubleshooting; Environmental Protection; Technical Specifications - Metabo BE 751 Original Instructions Manual

17027000_0910 B_Bauk10 BE 751 BE 1100.book Seite 13 Mittwoch, 15. September 2010 8:53 08

11 Troubleshooting

If it is not possible to press in the trigger (9),
check if the rotation selector switch (7) is fully at
position R or L.
Electronic signal display (6)
Rapid flashing - restart protection
(BE 1100)
When power is restored after a power failure, the
machine - which is still switched on - will not start
by itself for safety reasons. Switch machine on and
off again.
Slow flashing - carbon brushes worn
(BE 1100)
The carbon brushes are almost completely worn.
If the brushes are completely worn, the machine
switches off automatically. Have the brushes
replaced by an authorised service centre.
Permanently lit - overload
(BE 1100)
If the machine is subject to continuous overloading
for longer periods, the power input to the machine
is limited. This prevents additional unauthorised
heating of the motor.
12 Accessories
Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
The dealer needs to know the exact model of your
power tool in order to select the correct accessory.
See page 4.
A Metabox
B Angle drilling and screwdriving attachment
C Flexible shaft
D Flap sanding wheel
E Drill stand
F Machine vice
G Steel-wire end brush
H Steel-wire cup brush
I Steel-wire wheel brush
J Bit clamping bush
For the complete range of accessories, see
www.metabo.com or refer to the main catalogue.
13 Repairs
Repairs to electrical tools must be carried out by
qualified electricians ONLY!
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
When returning the device for repair, please
enclose a description of the fault.

14 Environmental Protection

Metabo's packaging can be 100% recycled.
When they reach the end of their service life, power
tools and accessories contain considerable
amounts of valuable raw and plastic materials,
which can be recycled.
These instructions are printed on chlorine-free
bleached paper.
Only for EU countries: Never dispose of
power tools in your household waste!
In accordance with European Guideline
2002/96/EC on used electronic and electric
equipment and its implementation in national
legal systems, used power tools must be collected
separately and handed in for environmentally
compatible recycling.

15 Technical Specifications

Explanatory notes on the information on page 2.
Changes due to technological progress reserved.
P = Rated input
1
P = Power output
2
n * = No-load speed
1
n * = Load speed
2
ø max = Max. drill diameter
s max = Max. impact rate
b = Chuck capacity
G = Drill spindle thread
H = Drill spindle with hexagon socket
m = Weight
D = Collar diameter
Vibration total value (vector sum of three
directions) determined in accordance with
EN 60745:
a = Vibration emission value
h, ID
(impact drilling into concrete)
a = Vibration emission value
h, D
(drilling into metal)
K ,K = Uncertainty (vibration)
h,ID h,D
The vibration level specified in these instructions
has been measured using a procedure standard-
ised in EN 60745 and can be used for comparing
power tools with one another. It is also suitable for
a provisional estimate of the vibratory load.
The specified vibration level applies to the main
applications of the power tool. However, if the tool
is used for other applications, with different acces-
sories or is poorly maintained, the vibration level
may vary. This may significantly increase the
vibratory load over the entire working period.
ENGLISH
ENG
13