Jenn-Air JED8130 Installation Manual page 7

2_0EdwardsStreet,SE
Cieve!and, T en_esse_ 37311
Tei: _13-472-3_3
Fax:a23-47S-87tO
16. CONNECT ELECTRICAL (FOUR CONDUCTOR WIRE)
- CAUTION: Make sure power to cable is OFF.
- Remove the range electrical service cover located on the back, lower left-band corner. Remove the
ground strap screw and bend the strap up as shown.
- install a 3/4" (1.19 cm) cable clamp in the hole provided, below the terminal block.
- Strip 3" (7.62 cm) of outer insulation from the cable.
- Strip 1/2" (1.27 cm) of insulation from each wire.
- Pull the cable through the cable clamp.
- Make a loop in the bare ground wire and attach it to the range with the sCrew that held the ground
strap.
- Attach the BLACK, RED, and WHITE wires (see #15). Tighten the terminal block nuts and the
cable clamp.
- Tape the ground stra to the WHITE wire as shown. InstaLlelectrical cover.
up II I I
17. INSTALL OPTIONS
- If a backsplash or side panels are to be used, install according to instructions included with those
accessories.
,/i I i :
: /
0- I I il
18. POSITION RANGE
- Free-Standing: Adjust the range feet so the range and cabinet height will be approximately the
same. Slide the range into place, taking care not to daraage floor covering.
- Slide-In: Carefully lit_ and place the range on the cabinet top.