Jenn-Air JED8130 Installation Manual page 4

240 Edwards$[reer. SE
Cleveland,Tennessee 373;;
Te}:_23-472-3333
Fax:423-4788710
7. SLIDE-IN CUTOUT
-Check yourmarked-updimensions carefully. The rear dimensions s hown intheillustration must
be maintained.
-NOTE: Where this isnotdone,itwill be necessary t orelieve a portion o ftheunderside oftbe
countenopand/or support members toclear therangerear panel.
- Cutting tolerance is 4- 1/16" (.16 cm). ._ .., _=" _,_
- Carefully mark the cutout. ___,,._Top ""-. ,,_- tltu. --
aT
_)
I%" I
8. OVER-RANGE CABINETS %
- To eliminate the hazard of reaching over a heated surface unit, cabinet storage space above the
range should be avoided. However, if over-range cabinets are necessary, observe the following:
B = 30" (76.2 cm) minimum clearance between the top oftbe cooking platform and the
bottom of an unprotected wood or metal cabinet.
B = 24" (60.96 era) minimum when bottom of wood or metal cabinet is protected by not
less than 1/4" (0.635 era) FLAME RETARDANT millboard covered with not less than
No. 28 MSG sheet steel, 0.015" (0.038 era) stainless st_l, 0.024" (0.061 cm) aluminum
or copper.
- If unit will be vented through the wall, go to #12.
- Using a square and marking pen, draw the "T" cutout line on the floor (see illustration). Recheck
your dimensions.
- If floor will be concrete slab, see enclosed ducting instructions.
- For left and right hand venting through cabinet toe space, see enclosed ducting instructions.
• 10%_
j S"
'7- L_... J .,- Y
/ (le.sa,=mj- i_..wt='_)
[],MAY1-AG
Admlr,al 7J _
JENN-,.MI:I ._ ._ditcJl¢ C. , _e.f