Jenn-Air JED8130 Installation Manual page 6

2&OEawards$tree!, SE
C;a'leiand,Tennessee 37311
TeJ: J -23-,:77_-_333
Fax:_23--;78-_7!0
13. INSTALL BLOWER (PRIOR TO INSTALLING RANGE)
- Refer to your vent plan. It may be desirable to attach part of the ducting to the blower before it
is installed.
- Position the blower (see illustration) and attach it to the floor with at least two (2) screws.
- Apply duct tape around blower exhaust/duct joint.
THROUGH THROUGH
OUT$1OE WALL THE FLOOR
14, INSTALL ELECTRICAL oucr TAPE
- NOTE: Observe all local electrical codes.
- CAUTION: Make sure power to cable is OFF:
- Locate the electric power supply in the floor or wall, any place in the shaded areas which will
clear the blower.
- Direct Connect. Pull through 5' (152.4 era) of electrical cable.
- Use three or four conductor copper stranded power cable (see front cover for proper wire size). If
four conductor wire is used, see #16 for connection to range.
- See front cover for proper supply connection, j
1
4'h o (11.43_ -- J
t
5 FE_=TOF
ELECTRICAL CABLE
15. COI_E:CT ELECTRICAL (THREE CONDUCTOR W1KE)
- CAUTION: Make sure power to cable is OFF.
- Remove the range electrical service cover, located on the back, lower lefthand corner.
- l_tall a 3/4" (1.91 cm) clamp in the hole provided below the terminal block.
- Strip 3" (7.62 cm) of outer insulation from the cable.
- Strip I/2" (1.27 era) of insulation from each wire.
- Pull the cable through the cable clamp. Attach the BLACK, RED, and WHITE wires (see
illustration). Tighten the terminal block nuts and the cable clamp and i_tall cover.
_ C,_,BLE CLAMP