Free-Standing - Jenn-Air JED8130 Installation Manual

240 Edwards Street, SE
C/eve!and, Tennessee _73T 1
Tei: 4 22-472-3333
Fax: 423-478-6710
4. FREE-STANDING CUTOUT
- 30 1/8" (76.52 cm) minimum clearance is required.
- Carefully mark the counter top, recheck your dimensions and make the cutout.
- NOTE: Range side panels may be desirable if the cutout is too large or cabinets are on one side
of the range only.
5. MEASURE FOR SLIDE-IN CUTOUT
- Most standard counters are 7.5" (63.50 cm) deep, 36" (91.44 cm) high, and extend I" (2.54 cm)
over the cabinet front.
- Measure the countertop and overhang. _ /"
/" /
0
OVERHANG
• DIMENSION
6. SLIDE-IN CUTOUT
- Use the overhang measurement to figure the "A" dimension:
Overhang 1/2" (1.27 cm) to t" (2.54 cm) "A" =22 7/8" (58.1 lcm)
Overhang 1" (2.54 cm) to 1 3/4" (4.45 era) _A'= 23 3/16" (58.90 cm)
- Carefully mark the countertop and recheck your dimensions.
- Before you cut, check the rear countertop dimensions. (See#7).
[] .'vlA3"U_G Admiral 7| ..... ,.,:$NN-AJ_:I x'4"_taqi¢ C,."_