Basic Connections; Basic Connections - Kurzweil KME61 Musician's Manual

Chapter 2
SP2 Getting Started

Basic Connections

Connecting Power Supply
Before connecting the power supply, make sure your SP2 is off. After that, connect the plug to
the AC In connector on the rear panel.
For your safety, place the power supply somewhere dry and out of the way. Also, to prevent
overheating, do not cover the power supply with anything.
Caution : Use only the power supply that comes with your SP2.
Using a different power supply can cause serious damage to your instrument!
AC Adapter (9VAC, 2.0A)
Connecting to Your Audio System
The SP2 features balanced left and right analog audio outputs. For the best results, use balanced
cables to connect to balanced, line‐level inputs on your mixer or sound system.
It is very important to use proper type of cables. The cables should have each 1/4 inch stereo
( tip‐ring‐sleeve ) plugs on one end to connect to the SP2 and the other end of cable should have
the same 1/4 inch stereo plugs or XLR plugs. Using balanced cables will greatly reduces noise.
For the best audio quality
1. Set the volume level of your sound system to its minimum. Be cautious! Not doing so may
cause damage to your sound system such as speakers.
2. Set the SP2's volume level to its maximum.
When you connect audio cables, make sure to turn down the level on your
3. Adjust the volume of your sound system to the appropriate level.
4. The SP2 has a headphone jack which duplicates the signal from the main outputs. Plugging
into the headphone jack does not mute the other audio outputs. You can also use the
headphone jack as an unbalanced stereo line‐level output. In this case, just connect a stereo
cable from the headphone jack to a stereo input on any sound system.
２-2
< Figure 2‐2 > Connecting Power Supply
sound system.