Installing Liberty Identity Provider Software - Novell eBook Reader Administration Manual

The Novell-supported platform for installing the Liberty IDP is a Windows* 2000 server or
workstation.
To run the Liberty IDP, you must have:
For additional information and full system requirements for Novell eDirectory 8.7, refer to the
Novell eDirectory 8.7 Quick Start, available at the
www.novell.com/documentation/lg/edir87/index.html).
You can download Novell eDirectory at
download.novell.com).

Installing Liberty Identity Provider Software

To install a basic Liberty IDP infrastructure, complete the following procedures:
Installing Liberty Identity Provider Software
The Liberty IDP software should only be installed on compatible hardware (see
Provider Requirements" on page
introduction, a pre-installation summary, the Liberty IDP installation, and a completion record. At
any given point of the installation process, you can follow the progress of your installation by
referring to the left-hand side of the install dialog. (See
To install the Liberty IDP:
10
Liberty Identity Provider for Novell eDirectory
a static IP address
an iManager-compatible browser: Internet Explorer 5.5 or above, or Netscape* 6.2 or above
"Installing Liberty Identity Provider Software" on page 10
"Installing the Liberty Administration Plug-ins When iManager is Already Installed on Your
eDirectory Server" on page 19
1
At the Web download site, click the Web download link to automatically download the Liberty
IDP executable.
2
Run the executable.
InstallAnywhere* will guide you through the installation process.
3
After you have read the introductory screen, click Next.
Novell Documentation site (http://
Novell Software Downloads (http://
9). The installation is divided into four sections: an installation
Figure
"Liberty Identity
1.)