Creating A Liberty Idp Site; Set Up A Liberty Idp Site; Chapter 3, "Creating A Liberty Idp Site - Novell eBook Reader Administration Manual

3

Creating a Liberty IDP Site

After you have installed the Liberty identity provider for Novell
step is to set up a Liberty identity provider (Liberty IDP) site. You cannot run Liberty unless you
set up an identity provider site.
IMPORTANT:
provider (SP). Therefore, you should install and configure an SP in your Liberty environment you complete
your Liberty IDP configuration. For information about SPs, see
Sample Service Provider," on page
This chapter explains the tasks you need to complete to set up a basic Liberty identity provider site.
Creating a Liberty IDP Site
Complete the following tasks to configure your Liberty IDP:

1. Set Up a Liberty IDP Site

Complete the following steps to set up a Liberty IDP site:
As part of the Liberty IDP configuration, the IDP references information about the service
1. Set Up a Liberty IDP Site
2. Define Site Properties
3. Define Service Providers
4. Set Up Your Liberty Identity Server
5. Manage Your Federations
1
Launch iManager and log in to your server.
You launch iManager by opening a Web browser and going to https://<ipaddress>/eMFrame/
iManager.html (case-sensitive), where <ipaddress> is the address of your server. For detailed
instructions on how to launch iManager, see the "Novell Web Applications," html document
that was placed on your desktop as part of the iManager installation.
For iManager documentation, see the
www.novell.com/documentation/lg/imanager151/index.html).
2
Under Roles and Tasks, expand the Liberty Management menu, then click the Manage Sites
task.
This takes you to the Manage Liberty Identity Sites page.
33.
iManager 1.5.1 Administration Guide (http://
®
eDirectory software, your next
TM
Appendix A, "Installing and Configuring a
Creating a Liberty IDP Site
21