Adjusting The Anti-Scalp Rollers - Toro TITAN ZX 4800 Operator's Manual

4. Push on the deck lift pedal with your foot and pull
the handle rearward to disengage the transport lock
(Figure 21).
5. Lower the deck slowly until the lever makes contact
with the pin.
2
1
Figure 22
1. Deck lift pedal
2. Handle
3
4
g024410
3. Height-of-cut positions
4. Pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is recommended
to adjust the height of the anti-scalp rollers.
1. Disengage the blade control switch (PTO), move the
motion control levers to the neutral lock position and
set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Remove the flange nut, anti-scalp roller and bolt from
the bracket (Figure 23).
Note: Keep the bolt and anti-scalp roller together
when removing.
1
2 3
1. Flange Nut
2. Spacer
3. Anti-scalp roller
4. Align the bolt and anti-scalp roller in the hole of the
bracket that matched the closest height of cut position
(Figure 23).
5. Insert the bolt into the bracket hole and secure the bolt
and anti-scalp roller with the flange nut (Figure 23).
22
g024312
4
Figure 23
4. Bushing
5. Bolt
5