Servicing The Engine Oil - Toro TITAN ZX 4800 Operator's Manual

Model no. 74851-serial no. 314000001 and up model no. 74852-serial no. 314000001 and up model no. 74853-serial no. 314000001 and up model no. 74855-serial no. 314000001 and up
Hide thumbs Also See for TITAN ZX 4800:
Table of Contents

Advertisement

Cleaning the Element
Service Interval: Every 100 hours—Service the paper
element. (more often in dusty, dirty
conditions)
Every 200 hours/Yearly (whichever comes
first)—Replace the paper element. (more often in
dusty, dirty conditions)
1. Lightly tap the element on a flat surface to remove dust
and dirt.
2. Inspect the element for tears, an oily film, and damage
to the seal.
Important: Never clean the paper element with
pressurized air or liquids, such as solvent, gas,
or kerosene. Replace the paper element if it is
damaged or cannot be cleaned thoroughly.

Servicing the Engine Oil

Engine Oil Specification
Oil Type: Detergent oil (API service SF, SG, SH, SJ, or SL)
Crankcase Capacity: 1.8 liter (61 ounce); when oil filter is
removed: 2.1 liter (70 ounce)
Viscosity: See the table below:
SAE V iscosity Grades
SAE 10W30/ SAE 10W40
SAE 5W
20
-20
0
20
°F
°C
-30
-20
-10
STARTING TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
Figure 30
Note: Using multi-grade oils (5W-20, 10W-30, and 10W-40)
will increase oil consumption. Check oil level more frequently
when using them.
Checking the Engine Oil Level
Service Interval: Before each use or daily
Note: Check the oil when the engine is cold.
WARNING
Contact with hot surfaces may cause personal
injury.
Keep hands, feet, face, clothing and other body
parts away the muffler and other hot surfaces.
SAE 40
SAE 30
32
40
60
80
100
0
10
20
30
40
g017470
Important: Do not overfill the crankcase with oil
because damage to the engine may result. Do not run
engine with oil below the low mark because the engine
may be damaged.
1. Park the machine on a level surface, disengage the
blade control switch, stop the engine, engage parking
brake, and remove the key.
2. Make sure the engine is stopped, level, and is cool so
the oil has had time to drain into the sump.
3. To keep dirt, grass clippings, etc., out of the engine,
clean the area around the oil fill cap/dipstick before
removing it (Figure 31).
1
3
6
8
29
2
4
5
7
9
10
Figure 31
G0201 15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Titan zx6000Titan zx 5400

Table of Contents