Masonry Fireplace - Regency F3500 Owners & Installation Manual

installation

MASONRY FIREPLACE

There are listed kits available to connect a stove to a masonry
fireplace. The kit is an adapter that is installed at the location
of the fireplace damper. The existing damper may have to
be removed to allow installation.
Minimum vertical of 36" before any offset.
Horizontal Maximum of 36" with 1/4" rise per foot.
NOTE: Recommend using 2-45º instead of 90º to improve
draft and performance.
Single
Double
NOTE: Only a 6" and or 5.5" liner may be used when relin-
ing the masonry chimney. Do not increase/decrease size
18" 6"
of the liner as this could result in poor performance, over
[457mm] [152mm]
firing and or dangerous operating conditions which may
void your warranty.
Min. 36"
Vertical
Do not use or add a pipe damper as this will result in poor
Max. 36"
Rise Horizontal
performance, over firing and or dangerous operating condi-
tions which may void your warranty. This appliance already
has a bypass damper in place.
10"
[254mm]
A minimum vertical rise of 36 inches is required from
top of stove collar prior to having any offset. It is recom-
mended that 45º elbows be used instead of a 90º elbow
to improve draft and performance. If not adhered to this, it
will result in poor performance overfiring and or dangerous
operating conditions which may void your warranty.
F3500 Regency Freestanding Woodstove
10