Power Terminal Block; Figure 8 Configuring Standalone Bips To Report Alarm Status - Nortel 8010co Installation Manual

This type of configuration allows you to independently monitor and control the
external audible and visual alarm status indications of the BIP at the central office.

Figure 8 Configuring standalone BIPs to report alarm status

J1
J2
J3
1
J4
J5
To central office
To central office
To central office
1 = J5 (standalone office alarm connector)

Power terminal block

The power terminal block is located on the back panel of the BIP. As shown in
Figure 9 on page
DC input and output feeds.
Installing the Breaker Interface Panel for the Ethernet Routing Switch 8010co Chassis
3 2 1 3 2 1
PS (+) PS (+) A/B Input Feed
Lower Shelf Upper Shelf Returns
3 2 1 3 2 1
PS (+) PS (+) A/B Input Feed
Lower Shelf Upper Shelf Returns
3 2 1 3 2 1
PS (+) PS (+) A/B Input Feed
Lower Shelf Upper Shelf Returns
28, the power terminal block provides 21 connection blocks for
Chapter 1 Overview
3 2 1 3 2 1 A 1 A 2 B 1 B 2
PS (-) PS (-) – 48 VDC
Lower Shelf Upper Shelf A/B Input Feeds
BIP 1
1 2 1 2
3 2 1 3 2 1 A A B B
PS (-) PS (-) – 48 VDC
Lower Shelf Upper Shelf A/B Input Feeds
BIP 2
3 2 1 3 2 1 A 1 A 2 B 1 B 2
PS (-) PS (-) – 48 VDC
Lower Shelf Upper Shelf A/B Input Feeds
BIP 3
27
10419EA