Wireless Lan Card - Toshiba satellite A20 series Maintenance Manual

4.12 Wireless LAN Card

4.12 Wireless LAN Card
Removing the Wireless LAN Card
To remove the wireless LAN card, make sure the computer is in boot mode and powered off,
follow the steps below and refer to figures 4-19 and 4-20.
NOTE: The wireless LAN card is an option in some models. This computer supports two
types of wireless LAN (802.11/b or 802.11a/b combo). In this section, removing/installing
a wireless LAN card for a/b combo model is described for example.
CAUTION: Do not try to remove the wireless LAN card with the computer turned on.
You can damage the computer or the wireless LAN card. Do not touch the connectors on
the wireless LAN card module on the computer. Debris on the connectors may cause
wireless LAN card access problems.
1. Turn up the keyboard insulator.
2. (For a/b combo models)
Remove the following screw securing the wireless LAN card cover.
• M2×4 LH STICK screw
M2×4 LH STICK screw
Wireless LAN card cover
Figure 4-19 Removing the Wireless LAN card cover
Satellite A20 Maintenance Manual (960-444)
×1
Keyboard insulator
4 Replacement Procedures
4-37