Toshiba satellite A20 series Maintenance Manual page 390

4.30 Fluorescent Lamp
Assembling the 14.1-inch XGA TOSHIBA Fluorescent Lamp
To assembling the 14.1-inch XGA TOSHIBA fluorescent lamp, follow the steps below and
refer to figures 4-143 to 4-149.
Putting the double-sided tapes on the bezel
1. Attach the double-sided tape to the reverse side of the bezel, as shown in Figure 4-
143.
The end of tape must
not go beyond the
opening of bezel. ƒe[ ƒv'[‚ªƒxƒ[ƒ‹ŠJŒû "‚æ‚è
‰z‚¦‚È‚¢‚±‚Æ
Figure 4-143 Attaching double-sided tape to the bezel's reverse side
Satellite A20 Maintenance Manual (960-444)
Reverse side of the bezel
ƒxƒ[ƒ‹— –Ê
Requirements for attaching
double–sided tape
—¼–ʃe[ ƒv"\‚è‹KŠi
Tape must not go beyond Double-sided tape
the opening of the bezel.
(4597, Sumitomo 3M)
ƒxƒ[ƒ‹ŠJŒû "‚æ‚è
ƒe[ ƒv‚Ì‚Í‚Ýo ‚µ–³‚«‚±‚Æ —¼–ʃe[ ƒvF ‚S‚T‚X‚Vi Z —F‚R‚lj
(tape length)
285 } 0.5 i ƒe[ ƒv'·‚³j
4 Replacement Procedures
The end of tape must not go
ƒe[ ƒv'[‚ªƒxƒ[ƒ‹ŠJŒû "‚æ‚è
beyond the opening of bezel.
‰z‚¦‚È‚¢‚±‚Æ
Tapes must not be overlapped.
ƒe[ ƒv"¯ ud ‚È‚ç‚È‚¢‚±‚Æ
4-185