Stamina aeropilates premier 299 Owner's Manual page 8

ASSEMBLY INSTRUCTIONS
NOTE: The securing SCREWS(M6x1x35mm)(36) for the PULLEY SET(22) on each side may need
to be loosened to allow the REAR COVER(4) to fit securely over the frame. Refer to the inset
illustration. Before removing the paper covering from the foam tape inside the REAR COVER(4),
place the REAR COVER(4) onto the REAR FRAME(2) and make sure that the SCREWS
(M6x1x35mm) are correctly tightened to allow the REAR COVER(4) to fit securely over the
frame. The PULLEY SETS(22) should swivel freely.
STEP 4
Remove the paper covering from the foam tape inside the FRONT COVER(3) and REAR COVER(4).
Place the FRONT COVER(3) over the end of the FRONT FRAME(1). Place the REAR COVER(4) over
the end of the REAR FRAME(2). Press the covers securely in place.
STEP 5
Insert the FOAM PAD ASSEMBLIES(17) into the holes located on the CARRIAGE(7).
8