Samsung DMT300 Series Service Manual page 24

3. Disassembly and Reassembly
4. Remove the cover fan by rotating it counterclockwise.
Use a jig. If you have no jig, use a tool such as a pair
of long nose pliers. Remove it carefully so that the part
is not damaged.
5. Remove the two (2) screws holding the cover fan in
place.
3-15
6. Hold and remove both the case vent assy which are
located at the front of the tub front.
7. Remove the fan motor from the case vent assy.
It is connected with two (2) screws and the fan vent is
inserted into the shaft of the fan motor. Remove the
screws first and carefully pull out the fan motor.
8. Release the three (3) screws at side of case vent.
Copyright© 1995-2010 SAMSUNG. All rights reserved.