Drain Pump - Samsung DMT300 Series Service Manual

3. Disassembly and Reassembly

3.2.3. Drain Pump

1. Place the dishwasher on its back so that you can see the
base. Remove the two (2) screws that hold the base and
the shutter in place.
2. Remove the leakage sensor connector (white) in the
shutter.
3-5
3. Disconnect the two (2) drain pump connectors.
4. Remove the drain pump by rotating it counterclockwise.
When removing the drain pump, lift up the hook
holding it in place slightly and then rotate it so that the
hook is not damaged.
Copyright© 1995-2010 SAMSUNG. All rights reserved.