Samsung DMT300 Series Service Manual page 13

5. Place the dishwasher on its back so that you can see the
base. Remove the two (2) screws that hold the base and
the shutter in place.
CAUTION
Before placing the dishwasher on its back, make
sure to check whether any water is left. Remove
any remaining water. (There is a risk of fire due to
a water leakage while servicing).
6. Remove the leakage sensor connector (white) in the
shutter.
7. Remove the two (2) terminals which are inserted into
the heater
Do not pull the wire. Remove it by holding the metallic
part at the end of the wire.
Copyright© 1995-2010 SAMSUNG. All rights reserved.
8. Remove the two (2) holder heaters which are connected
to the heater by rotating them counterclockwise.
9. Place the dishwasher the right way up again. Open the
door and hold and remove the heater.
CAUTION
The heater may be very hot. Make sure to check it
before touching the heater.
CAUTION
Make sure to check whether any water is left.
Remove any remaining water, to prevent water
leakages while servicing.
3. Disassembly and Reassembly
3-4