Samsung DMT300 Series Service Manual page 20

3. Disassembly and Reassembly
2. Remove the fan motor & thermal actuator connectors.
3. Now remove the frame front and the panel control assy.
Place it on the floor and perform the following: Remove
the panel control from the frame front. You can remove
the panel control by holding and pulling it.
And, you can remove and replace the door lock switch
in this step. (Remove both connectors of door lock
switch.)
3-11
4. Remove the four (4) screws holding the PCB assy and
panel control in place.
Remove all the connectors connected to the PCB assy.
5. You can remove the PCB assy.
6. Remove the three (3) screws holding the PCB tact assy
and panel control in place.
Copyright© 1995-2010 SAMSUNG. All rights reserved.