Samsung DMT300 Series Service Manual page 16

3. Disassembly and Reassembly
5. Remove the screws and lift up and remove the cover
sump. The cover sump, cover scroll, assy filter mesh,
holder nozzle L, and cover heater will be removed
together.
CAUTION
Place the removed parts in a safe location to prevent
them from being damaged.
6. Remove the Impeller circulation.
Remove the screw (1) that is holding the circulation
motor to the shaft. Use your hand to hold the impeller
circulation and turn the screw.
CAUTION
Turn the screw clockwise to remove it.
3-7
7. Remove the valve distributor.
Remove the seal distributor.
CAUTION
Make sure to check whether any water is left.
Remove any remaining water to prevent water
leakages while servicing.
8. Remove the case scroll.
Check if the seal rubber scroll is normal. If it is
damaged or hardened, replace it.
9. Remove the cutter disposer.
CAUTION
Both sides are sharp. Be careful when removing it.
Copyright© 1995-2010 SAMSUNG. All rights reserved.