Hotpoint OK 1037ELDP.20 X/HA S Operating Instructions Manual page 40

! If the oven is too hot, the pyrolytic cycle may not start.
GB
Wait for the oven to cool down.
! The programme may only be started once the oven door
has been closed.
To activate the Fast Clean programme:
1. Switch the control panel on by pressing the
2. Press the button; the TIME display will show the default
duration of 1:30 h (normal cycle), while he TEMPERATURE
display will show "Piro" and "nor" alternately;
3. The desired cleaning level can be selected by pressing
the button, then:
- pressing to switch to the intensive cycle: the duration is
2 h and the TEMPERATURE display shows the text "Piro"
and "int" alternately;
- pressing to switch to the economy cycle: the duration is
1 h and the TEMPERATURE display shows the text "Piro"
and "eco" alternately.
Safety devices
• the door locks automatically as soon as the temperature
reaches a high value; the
display;
• pressing the button cancels the cleaning cycle t any
time;
• if a malfunction occurs, the heating elements will be
switched off;
• once the oven door has been locked, you cannot change
the duration and end time settings.
Programming delayed automatic cleaning
! Programming is possible only after selecting the FAST
CLEAN mode.
1. Press the button and set the end time using the
and buttons.
2. Once you have reached the desired end time, press the
button again.
3. Press the button to activate the programmed mode.
4. When the selected time has elapsed, "END" appears on
the TEMPERATURE display and a buzzer sounds.
• For example: it is 9:00 a.m. and the Economy (ECO)
FAST CLEAN level has been selected, with the default
duration of 1 hour. 12:30 is scheduled as the end time.
The programme will start automatically at 11:30 a.m.
The icons and
has taken place. After programming, in the time before the
Fast Clean mode starts, the TIME display indicates the
duration and end of the Fast Clean mode alternately.
To cancel programming press the
40
icon lights up on the
flash to indicate that programming
button.
Once the automatic cleaning cycle is over
Before you can open the oven door, you will have to wait
for the icon to switch off: this indicates the oven
temperature has dropped to an acceptable level. You will
notice some white dust deposits on the bottom and the sides
of your oven; remove these deposits with a damp sponge
once the oven has cooled down completely. Alternatively,
you can make use of the already heated oven, in which
button.
case it is not necessary to remove the deposits, they are
completely harmless and will not affect your food in any way.