Installing The Water Dispenser Line - Samsung RS-21 KLMR User Manual

CHECKING THE WATER
DISPENSER LINE (OPTIONAL)
A water dispenser is just one of the helpful features
on your new Samsung refrigerator. To help promote
better health, the Samsung water fi lter removes
unwanted particles from your water. However, it
does not sterilize or destroy microorganisms. You
will need to purchase a water purifying system to do
that. In order for the icemaker to operate properly,
water pressure of 138 ~862 Kpa is required. Under
normal conditions, a 170 cc paper cup can be fi lled
in 10 seconds. If the refrigerator is installed in an
area with low water pressure (below 138 Kpa), you
can install a booster pump to compensate for the
low pressure. Make sure the water storage tank
inside the refrigerator is properly fi lled. To do this,
press the water dispenser lever until the water runs
from the water outlet.
Water Line installation Kits are included. You
can fi nd it in one of the freezer drawers.
INSTALLING THE WATER
DISPENSER LINE
For Interior model
Parts for water line Installation
1 Water line fi xer and screws Water line fi xer and screws
3 Water line Water line
Connecting to the water supply line
1. First, shut off the main water supply line.
2. Locate the nearest cold, drinking water line.
3. Follow the water line installation instructions in
the installation kit.
The water line must be connected to the cold
water pipe. If it is connected to the hot water
pipe, it may cause the purifi er to malfunction.
Downloaded from Fridge-Manual.com Manuals
DA99-02028F(0.5).indb 11 DA99-02028F(0.5).indb 11
2
Pipe connector Pipe connector
4
Water Filter Water Filter
CAUTION
4. After connecting the water supply to the water
fi lter, turn your main water supply back on and
dispense about 1l to clear and prime the water
fi lter.
Close Main Close Main
Water pipe Water pipe
Close Main Close Main
Water pipe Water pipe
Connecting the water line to the
refrigerator
1. Remove the dust cap from the water line on the
rear of the unit and fi t a compression nut from the
install kit.
2. Remove the water pipe from the install kit and fi t
a compression nut to one end.
3. Join the two pipes together using the
compression joint from the install kit ensuring that
the joint is water tight.
4. Join the other end of the install pipe to the main
water supply and turn on the water to check for
leaks.
Remove Remove
Loosen a Loosen a
cap cap
Water Line Water Line
from unit from unit
Water Line Water Line
from Kit from Kit
Only connect the water line to a drinkable
water source. If you have to repair or
disassemble the water line, cut off 6.5mm
of the plastic tubing to make sure you get a
snug, leak-free connection.
Before being used, the leakage in these
places should be examined
CAUTION
No gap No gap
No gap No gap
setting up _11
2012.2.14 2:24:0 PM 2012.2.14 2:24:0 PM