Adjusting The Freezer Drawer Level; Installing The Water Dispenser Line; Connecting To The Water Supply Line - Samsung RF4289HA User Manual

ADJUSTING THE FREEZER
DRAWER LEVEL
Adjustment part j j p p
1. Locate the height-adjuster (
drawer. Unscrew the 8 Phillips screws ( 2 )
slightly to loosen the door.
2. Loosen the controller screw
( 3 ) with a Phillips screwdriver
(+).
3. Find the best level to align the door slope.
• After adjustment, tighten the controller screw
( 3 ) and then the philips screws.
Example) The slope is about 0.08inch (2mm) as shown below. Example) The slope is about 0.08inch (2mm) as shown below.
- Rotate the height adjuster to -2.0 to reduce the door slope. - Rotate the height adjuster to -2.0 to reduce the door slope.
Slope Slope
Reference plane Reference plane
DA68-02520A(1.0).indb 11 DA68-02520A(1.0).indb 11
Freezer Dra Freezer Dra Freezer Drawer r r r r r
1 ) in the freezer
1
2
3
INSTALLING THE WATER
DISPENSER LINE
A water dispenser with a fi lter is one of the helpful
features on your new refrigerator. To help promote
better health, the water fi lter removes unwanted
particles from your water. However, it does not
sterilize or destroy microorganisms. You may need
to purchase a water purifying system to do that.
In order for the ice maker to operate properly, a
water pressure of 20~125 psi is required.
Under normal conditions, a 170 cc (5.75 oz.) cup
can be fi lled in about 10 seconds.
If the refrigerator is installed in an area with low
water pressure (below 20psi), you can install a
booster pump to compensate for the low pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator is
properly fi lled. To do this, press the water dispenser
lever until the water runs from the water outlet.
Water line installation kits are available at
extra cost from your dealer.
We recommend using a water line
installation kit that contains copper tubing
and ¼" compression nut.

Connecting to the water supply line

1. First, shut off the main water
supply.
2. Locate the nearest cold water drinking line and
install the pipe clamp and shut off valve.
Cold water line Cold water line
Pipe clamp Pipe clamp
Shut off valve Shut off valve
3. Connect the water line installation kit to the shut
off valve.
Cold water line Cold water line
Pipe clamp Pipe clamp
Shut off valve Shut off valve
Water line installation kit Water line installation kit
setting up _11
2012.5.30 10:40:8 AM 2012.5.30 10:40:8 AM