Installing The Water Dispenser Line - Samsung DA68-03316A User Manual

CHECKING THE WATER
DISPENSER LINE (OPTIONAL)
A water dispenser is just one of the helpful features on
your new Samsung refrigerator. To help promote better
health, the Samsung water fi lter removes unwanted
particles from your water. However, it does not sterilize
or destroy microorganisms. You will need to purchase
a water purifying system to do that. In order for the
icemaker to operate properly, water pressure of 138
~862 Kpa is required. Under normal conditions, a
170 cc paper cup can be fi lled in 10 seconds. If
the refrigerator is installed in an area with low water
pressure (below 138 Kpa), you can install a booster
pump to compensate for the low pressure. Make sure
the water storage tank inside the refrigerator is properly
fi lled. To do this, press the water dispenser lever until
the water runs from the water outlet.
Water Line installation Kits are included. You
can fi nd it in one of the freezer drawers.
The new hose-sets supplied with the
appliance are to be used and that old hose-
sets should not be reused.
INSTALLING THE WATER
DISPENSER LINE
For Interior model
Parts for water line Installation
1 Water line fixer and screws Water line fixer and screws
3
Water line Water line
Connecting to the water supply line
1. First, shut off the main water supply line.
2. Locate the nearest cold, drinking water line.
3. Follow the water line installation instructions in
the installation kit.
CAUTION
The water line must be connected to the cold
water pipe. If it is connected to the hot water
pipe, it may cause the purifier to malfunction.
DA68-03316A-00.indb 18 DA68-03316A-00.indb 18
4. After connecting the water supply to the water
filter, turn your main water supply back on and
dispense about 1l to clear and prime the water
filter.
Connecting the water line to the
refrigerator
1. Remove the dust cap from the water line on the
rear of the unit and fit a compression nut from the
install kit.
2. Remove the water pipe from the install kit and fit
a compression nut to one end.
3. Join the two pipes together using the
compression joint from the install kit ensuring that
the joint is water tight.
4. Join the other end of the install pipe to the main
water supply and turn on the water to check for
leaks.
2
Pipe connector Pipe connector
4
Water Filter Water Filter
CAUTION
English - 18
Close Main Close Main
Water pipe Water pipe
No gap No gap
Close Main Close Main
Water pipe Water pipe
Remove Remove
Loosen a Loosen a
cap cap
Water Line Water Line
from unit from unit
No gap No gap
Water Line Water Line
from Kit from Kit
Only connect the water line to a drinkable
water source. If you have to repair or
disassemble the water line, cut off 6.5mm
of the plastic tubing to make sure you get a
snug, leak-free connection.
Before being used, the leakage in these
places should be examined
2015. 3. 10. 2015. 3. 10. 7:15 7:15