NordicTrack AudioRider NTEX4196.0 User Manual page 5

2. While another person lifts the rear of the Frame (1),
attach the Rear Stabilizer (16) to the Frame with four
M8 x 50mm Button Screws (52) and four M8 Split
Washers (55).
3. Tighten the Upright Knob (7) into the Frame (1).
4. While another person holds the Upright (2) near the
Frame (1), use the wire tie in the Upright to pull the
Upper Wire Harness (42) through the Upright. See the
inset drawing. Tie the end of the wire tie to the Upper
Wire Harness. Then, pull the other end of the wire tie
upward out of the top of the Upright. Remove and dis-
card the wire tie.
Attach the Upright (2) to the Frame (1) with an
M10 x 63mm Bolt Set (62). Be careful to avoid
pinching the Upper Wire Harness (42).
5. The Console (4) requires four "D" batteries
(not included); alkaline batteries are recommended.
Remove the battery covers from the back of the
Console. Next, insert four batteries into the battery
compartments; make sure that the batteries are ori-
ented as shown by the diagrams inside the battery
compartments. Then, reattach the battery covers.
Note: The Console (4) can be operated with an
optional power supply instead of batteries. To pur-
chase a power supply, call the toll-free telephone
number on the front cover of this manual. Plug one
end of the power supply into the jack at the front of
the exercise cycle. Plug the other end of the power
supply into an appropriate outlet that is properly
installed in accordance with all local codes and ordi-
nances.
2
1
16
3
7
4
Avoid pinching
and damaging
the wire harness.
2
62
5
Batteries
4
5
55
55
52
52
1
42
Wire Tie
62
42
1
Battery
Covers
Batteries