Assembly - NordicTrack AudioRider NTEX4196.0 User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own adjustable wrench
driver .
Use the part drawings below to identify the small parts used in assembly. The number in parentheses below
each drawing is the key number of the part, from the PART LIST on page 21. The number following the paren-
theses is the quantity needed for assembly. Note: Some small parts may have been pre-attached. If a part is
not in the parts bag, check to see if it has been preattached.
M6 Washer M8 Split
(75)–4 Washer (55)–14
M6 x 30mm Button
Screw (37)–4
M8 x 50mm Button
Screw (52)–4
1. Orient the Left Front Stabilizer (15) with the Wheel (17)
in the position shown. Attach the Left Front Stabilizer
to the left side of the Frame (1) with three M8 x 16mm
Button Screws (54) and three M8 Split Washers (55).
Attach the Right Front Stabilizer (not shown) to the
right side of the Frame (1) in the same way.
M8 Nylon
Locknut (60)–4
M8 x 16mm Button M8 x 19mm Button
Screw (54)–6
M4 x 16mm
M4 x 12mm
Round Head
Screw (25)–1
Screw (80)–6
Screw (77)–4
M10 x 63mm Bolt
Set (62)–1
1
15
17
55
54
4
and Phillips screw-
M6 x 16mm Button
Screw (81)–4
M8 x 41mm Button
Bolt (45)–4
1
55
54