Keypad Functions - Honeywell ADEMCO LYNXR-ISIA Installation And Setup Manual

LYNXR-ISIA Installation and Setup Guide
System Operation

Keypad Functions

The keypad allows the user to arm and disarm the system, and perform other system functions, such as
bypassing zones. Zone and system conditions (alarm, trouble, bypass) are displayed in the display window.
When an alarm occurs, keypad sounding and external sounding will occur, and the zone(s) in alarm will be
displayed on the keypad. Pressing any key will silence the keypad sounder for 10 seconds (only once).
Disarming the system will silence both keypad and external sounders. When the system is disarmed, any
zones that were in an alarm condition during the armed period will be displayed (memory of alarm). To
clear this display, simply repeat the disarm sequence (enter the security code and press the OFF key). The
keypad also features chime annunciation, and 3 panic key pairs for silent, audible, fire or personal
emergency alarms. These keys can notify the central station of an alarm condition, if that service is
connected. A summary of system functions is provided below for more detailed information refer to the
User's Manual.
Security Functions
(Empty boxes represent the user's security code)
Checking system status:
messages
To arm in STAY mode:
To restart exit delay:
...............................
To arm in AWAY mode:
To arm with NO DELAY:
To arm if Quick Arm is programmed:
To disarm the system and silence alarms:
Note: During Entry Delay or when an Alarm Condition exists the system can be disarmed by entering the User Code. Entering the
key is not required.
To bypass a zone(s):
.................................
To turn Chime mode on or off:
Message Center
To record a message: .............................
To stop recording before end of 90 seconds:
To play back a message:........................
To skip a message: ................................ [
To delete all messages:..........................
Volume Control
To adjust message playback/system announcement volume:
To mute system announcements:
To restore/unmute announcement & volume:
Other Functions
To set the time and date:
To set the scheduling:
To activate or deactivate X10 devices 1-6:
To activate or deactivate X10 devices 7 & 8:
To add a user code:
.................................
To delete a user code (except Master Code):
To turn Test mode on:
To turn Test mode off:
.........................
STATUS
..........................
(applies only if system is armed in Stay mode)
STAY
...........................
........................
or
.. AWAY
..............
FUNCTION
FUNCTION
OFF
FUNCTION
]
✻
FUNCTION
......... FUNCTION
.......................
.............................
FUNCTION
.............................
.............................
(high level messages); press
+ (or installer code + [3])
STAY
+ (or installer code + [2])
AWAY
or
+
AWAY STAY
(hold down for at least 2 seconds)
STAY
+
OFF
+ + 2-digit zone number(s)
BYPASS
+
CHIME
+
RECORD
+
PLAY
+
(during message replay)
DELETE
FUNCTION
+ +
VOLUME OFF
+ + [3] or [6]
FUNCTION VOLUME
+ + [63]
FUNCTION
+ + [64]
FUNCTION
+ or
LIGHTS ON
+
FUNCTION
*
+ + user number + user's code (*master code)
CODE
*+
CODE
+
TEST
+
OFF
- 54 -
again for secondary
STATUS
+
NO DELAY
+ + [3] or [6]
VOLUME
+ device number
LIGHTS OFF
or
+
LIGHTS ON LIGHTS OFF
+ user number (* master code)
OFF
.
+ dev. No