Table of Contents
Advertisement
Connections
and Setup for
5.1ch Surround
This section describes the connections
and setup necessary to enjoy 5.1ch
(SYSTEM UP MODE) surround sound
together with your existing
components.
EN
6
Hooking Up the System
Checking the connection type
The connections differ according to the components used
together with the processing amplifier. Be sure to check
your existing components and the connection type
beforehand.
Existing components are:
a Stereo system
b Stereo amplifier
b
DHC-MD717 (This model
may not be sold in certain
countries)
Equipped with audio input
jacks for external
components?
You cannot use the processing amplifier with
your existing components. See "Connections and
Setup for 3ch Surround" on page 16.
Differences in functions for each
connection type
For connection type A, the volume adjustment is
controlled and the speaker volume balance set by the
TEST TONE function is constantly maintained by the
audio bus cord connection, so these items do not need to
be reset.
For connection type B, the volume control of the
connected stereo system or stereo amplifier changes only
the front speaker volume, disrupting the volume balance
set by the TEST TONE function.
To return each speaker to the original volume balance,
adjust the volume control of the connected component so
that the front volume matches that of the other speakers,
or do the TEST TONE adjustment again.
a
Yes
Type A
No
Yes
Type B
No
Advertisement
Table of Contents
