Table of Contents
Advertisement
7
Set the sub woofer connection status.
1 Press CURSOR
V
v
/
repeatedly until "WOOFER
*
[YES
]" appears in the display.
2 Press CURSOR
B
b
/
to select the sub woofer
connection status.
Sub woofer connection status
None
Connected
*
The last setting is stored in the memory, so [NO] may
appear instead.
8
To enjoy more accurate surround effects, skip to
step 2 of the following section "Setting the
distance to the speakers".
To complete the settings, press SET UP.
z
If the sound is distorted
Select "SMALL" for the center and rear speaker connection
settings. Note that "LARGE" should be normally selected to
obtain satisfactory surround effects.
Note
If you do not press CURSOR to start the setting operations within
approximately 8 seconds after pressing SET UP, the SET UP
button goes off.
Setting the distance to the speakers
— SET UP
Set the distance from the listening position to the speakers
to enjoy more accurate surround effects.
Setting
NO
YES
1
Press SET UP.
The SET UP button lights and "SPEAKER SETUP"
appears in the display.
2
Set the distance to the front speakers.
1 Press CURSOR
5.0
*
The value set last is displayed.
2 Press CURSOR
listening position to the front speakers.
You can set the distance in 0.1 m (10 cm) steps from
1 to 12 m.
1
V
v
/
repeatedly until "FRONT
*
meter" appears in the display.
B
b
/
to set the distance from the
L
R
C S.W
LS
RS
2,3,4
Input this
distance.
EN
13
Advertisement
Table of Contents
