Planet VRT-402N User Manual page 45

Add SBM Rules
Click on [Add] tab. You will see the following screen.
Configure [Add SBM] Settings following the instructions below.
Sequence Number
Rule Name
Rule Enable
Internal IP
Protocol
External Interface
Service Port Range
Bandwidth Allocation
Ratio
Download
Upload
Utilize Bandwidth More
than Guaranteed
This defines the sequence of the SBM rules. If a packet fits the conditions set
by the SBM rules, the packet will then be sorted according to the first SBM rule
from the top of the list.
Name of the SBM rule.
Enable/Disable this SBM rule
Set up the internal IP for this SBM rule.
Set up the protocol (TCP or UDP) for the ACL to be enabled.
Please select which External Interface (WAN1 or WAN2) you want a packet to
go through, IF the packet fits the condition of this SBM rule.
Set up the Service Port Range (e.g., HTTP is TCP/80) for the SBM to be
enabled.
By Ratio or By Bandwidth
The ratio of the whole bandwidth according to the External Interface.
Enter the reserved download bandwidth.
Enter the reserved upload bandwidth.
Check this box if you wish to allow the traffic confirming this SBM rule to be
able to utilize the whole bandwidth when the bandwidth is idle.
45