Planet VRT-402N User Manual page 42

Configure [Add - IPsec] Settings following the instructions below.
Sequence Number
Connection Name
Rule Enable
VPN Mode
Local External Interface
Local Internal IP Address
Local Netmask
Remote Gateway
Remote Subnet IP
Remote Netmask
Connection Initiation
IKE Key Mode
Preshared Key
L2TP Enable
Advanced Options
Phase 1 Mode
Phase 1 ID
Phase 1 Lifetime
Phase 2 Lifetime
Phase 1 Authentication
Phase I Encryption
Phase 1 Group Key
Management
Phase 2 Authentication
Phase 2 Encryption
Phase 2 Group Key
Management
This defines the sequence of the IPsec rules.
Name of the IPsec rule.
Enable/Disable this IPsec rule
Net-to-Net or Road Warrior
Choose the external WAN for the local VPN gateway.
Choose the subnet IP address for the VPN gateway.
Choose the netmask for the local VPN gateway.
Enter the IP address or domain name of the remote VPN gateway. This option is
needed in Net-to-Net mode.
Enter the subnet IP address of the remote VPN gateway. This option is needed in
Net-to-Net mode.
Enter the subnet netmask of the remote VPN gateway. This option is needed in
Net-to-Net mode.
Check the local VPN gateway to initiate the connection. This option is needed in
Net-to-Net mode.
PSK.
Enter the preshared key. The key should be at least 8-digit ASCII string.
Check the local VPN gateway to enable L2TP. This option is needed in Road
Warrior mode.
Check it if you need to configure the advanced options.
Main.
Enter the phase 1 ID.
Enter the phase 1 lifetime. This value is between 3600 and 28800 seconds.
Enter the phase 2 lifetime. This value is between 3600 and 28800 seconds.
Choose the phase 1 authentication as MD5 or SHA1.
Choose the phase 1 encryption as DES, 3DES or AES.
Choose the phase 1 group key management as DH1, DH2 or DH5.
Choose the phase 2 authentication as MD5 or SHA1.
Choose the phase 2 encryption as DES, 3DES or AES.
Choose the phase 2 group key management as DH1, DH2 or DH5.
42