GE JHP64G Use And Care Manual page 40

The Problem Solver
PROBLEM
OVEN WILL
OVEN LIGHT
DOES N~ WORK
ELECTRONIC
TOUCH PADS
WILL NOT WORK
ELECTRONIC
DISPLAY PANEL
GOES BLANK
OR BLINKS
FOOD DOES NOT
BROIL PROPERLY
FOOD DOES NOT
ROAST OR BAKE
PROPERLY
(continued)
POSSIBLE CAUSE AND REMEDY
Difficulty may be in the main distribution panel of your house by a blown oven
circuit fuse, a tripped oven circuit breaker, the main fuse or the main circuit breaker,
depending on nature of the power supply. If a circuit breaker is involved, reset it. If the
control box uses fuses, the oven fuse (a cartridge-type) should be changed BUT ONLY
BY SOMEONE FAMILIAR WITH ELECll?ICAL CIRCUITS. If after doing one of
these procedures, the fuse blows or circuit breaker trips again, call for service.
NOTE: Apartment tenants or condominium owners should request their building
management to perform this check before calling for service.
Oven controls not properly set.
Door left in locked position after cleaning.
Light bulb is loose or bulb is burned out.
Button operating oven light is defective.
If it cannot be reset by touching pads, electrical service to your residence has caused
interference signals on the main power line. Disconnect your cooking center at the
main fuse or circuit breaker panel. Wait one minute and reconnect power. Reset clock.
OVEN SET knob not set at BROIL.
. Improper shelf position is being used. Check Broiling Guide.
Necessary preheating was not done.
Food is being cooked on a hot pan.
Cookware is not suited for broiling.
Aluminum foil used on the broil rack has not been fitted properly and slit.
OVEN SET knob not set on BAKE.
OVEN TEMP knob not set correctly.
Shelf position is incorrect. Check Roasting or Baking Guide.
Oven shelf is not level.
Roasting pan is too small.
Improper cookware is being used.
A foil tent was not used when needed to slow down browning.
40