GE JHP64G Use And Care Manual page 35

NEVER USE A COMMERCIAL
OVEN CLEANER ON ANY P~T
OF YOUR MICROWAVE OVEN.
Wipe up spatters on the window
on the inside of the door daily.
Wash window, when it's soiled,
with a minimum of sudsy, warm
water. Rinse thoroughly and dry.
Wipe metal and plastic parts on
the inside of the door frequently.
Use a damp cloth to remove all
soil. DO N~ USE ABRASIVES,
such as cleaning powders or steel
and plastic pads. They may mar
the surface.
Door Surface.
When cleaning
surfaces of door and oven that
come together on closing the door,
use only mild, nonabrasive soaps
or detergents applied with a sponge
or soft cloth.
Using a Brown 'N Sear Dish?
Use Bon Ami" brand cleanser.
High heat generated on the bottom
of the Brown 'N Sear Dish can
cause scorched appearing stains
to bake onto the floor if grease is
present. These may be removed
with Bon Ami@ brand cleanser.
After using this cleaner, rinse and
dry thoroughly, following instructions
on can. Do not use it on the painted
surfaces such as the walls—it may
scratch the paint.
Plug-In Surface Units
Clean the area under the drip pans
often. Built-up soil, especially
grease, may catch fire.
Caution: Be sure all controls are
turned to OFF and surface units
are cool before attempting to
remove them.
To make cleaning easier, the plug-
in surface units are removable.
Lift a plug-in unit about 1" above
the drip pan—just enough to grasp
it—and you can pull it out.
Do not lift a plug-in unit more
than 1!' If you do, it may not lie
flat on the drip pan when you
plug it back in.
Repeated lifting of the plug-in
unit more than 1" above the drip
pan can permanently damage the
receptacle.
After removing a plug-in unit,
remove the trim ring and drip pan
under the unit and clean them
according to directions in the
Cleaning Guide on page 37. Wipe
around the edges of the surface unit
opening. Clean the area below the
unit. Rinse all washed areas with a
damp cloth or sponge.
35
R
R
To replace a plug-in unit:
.
First place the drip pan, then the
trim ring into the surface unit
cavity found on top of the cooktop
so the unit receptacle can be seen
through the opening in the pan.
Insert the terminals of the plug-in
unit through the opening in the drip
pan and into the receptacle.
Guide the surface unit into place
so it fits evenly into the trim ring.
Note: The drip pan must be under
the trim ring.
CAUTION
Do not attempt to clean plug-in
surface units in an automatic
dishwasher.
. Do not immerse plug-in surface
units in liquids of any kind.
. Do not bend the plug-in surface
unit plug terminals.
Do not attempt to clean, adjust
or in any way repair the plug-in
receptacle.