Cleaning And Maintenance; Venting System; Cleaning Glass; Pilot And Burner Flames - Vermont Castings ICFDV40LNTSC Installation And Operating Instructions Manual

CLEANING AND MAINTENANCE

Make sure the gas valve knob is in the "OFF" position.
Wait at least fi ve (5) minutes before start -ing maintenance.

VENTING SYSTEM

A qualifi ed agency should examine the venting system
annually.

CLEANING GLASS

Clean the ceramic glass periodically. Condensation will
sometimes form on the glass during a 0 startup. This is
normal for all gas fi replaces and inserts. This condensation
often attracts dust and lint to the surface of the glass. The
initial paint curing of the appliance can also leave a slight
fi lm on the glass. This is a temporary problem.
You should clean the glass after the fi rst two weeks of use.
After that, you should clean the glass no more than two or
three times a season. Use a mild glass cleaner to clean
the door. Do not use abrasive cleaners. They will damage
the glass surface.

PILOT AND BURNER FLAMES

Visually check pilot and burner fl ames periodically. Refer
to Figure 52 for typical burner fl ame. Refer to Figure 53
for typical pilot fl ame.
Figure 52 -
Typical Burner Flame
20304852
Figure 53 -
Typical Pilot Flame

FIREBOX CLEANING

•
Allow logs to cool completely before
cleaning. Logs reach high temperatures.
•
Make sure clearances to combustibles
leave enough room for maintenance and
service.
•
Carefully reassemble and reseal insert
properly after any cleaning or servicing.
1. Carefully remove log set, and embers from combustion
chamber.
2. Vacuum burner compartment thoroughly.
3. Vacuum any dust off logs.
4. Remove any lint from main burner and pilot.
LG1122
5. Carefully replace log set, and embers in their correct
positions. Refer to Pages 21 through 22.
6. Replace door.
7. Relight pilot. Refer to Page 25.
8. Turn on main burners.
ICFDV40 Fireplace Insert
Sensor
Thermopile
FP2453
37