Cleaning And Maintenance; Venting System; Cleaning Glass; Pilot And Burner Flames - Vermont Castings 380IDVNVSB Installation And Operating Instructions Manual

CLEANING and MAINTENANCE

Make sure the gas valve knob is in the "OFF" position.
Wait at least five (5) minutes before start ing maintenance.

VENTING SYSTEM

A qualified agency should examine the venting system
annually.

CLEANING GLASS

Clean the ceramic glass periodically. Condensation will
sometimes form on the glass during a cold startup. This is
normal for all gas fireplaces and inserts. This condensation
often attracts dust and lint to the surface of the glass. The
initial paint curing of the appliance can also leave a slight
film on the glass. This is a temporary problem.
You should clean the glass after the first two weeks of use.
After that, you should clean the glass no more than two or
three times a season. Use a mild glass cleaner to clean
the door. Do not use abrasive cleaners. They will damage
the glass surface.
Allow glass to cool completely before
cleaning.
Do not clean glass when it is hot.
Damage could occur.
20306756

PILOT AND BURNER FLAMES

Visually check pilot and burner flames periodically. Refer
to Figure 34 for typical burner flame. Refer to Figure 35
for typical pilot flame.
Figure 34 -
Typical Burner Flame Appearance
LG776
380IDV log flames
Thermocouple
Figure 35 -
Typical Pilot Flame
380IDV Fireplace Insert
Thermopile
FP1943
pilot flame
29