Electronic Dashboard - Snapper 2691249-00 Operator's Manual

Electronic Dashboard

See Figures 4, 5, and 6.
The electronic dashboard includes an easy-to-read
electronic display and maintenance minder. The electronic
display monitors critical mower information including fuel
level, running hours, and cutting height (see Figure 3).
The built-in maintenance minder tells you when to change
the oil, air filter, or sharpen the blades. An amber indicator
light turns on to alert you and the required maintenance is
displayed on the message panel. The electronic dashboard
also includes a digital clock.
A. Total Hours and Trip Hours
B. Indicator Light (see Message Panel)
C. Maintenance Display Modes
• Oil Change
• Replace Air Filter
• Sharpen Blades
D. Clock
E. Control Buttons
F. Fuel Level (Full/Empty)
G. Battery Voltage (High/Low)
H. Message Panel
• Low Fuel
• Low Battery
• Change Oil
• Change Air Filter
• Sharpen Blades
I. Height-of-Cut
Display Total Hours, Trip Hours, and Clock
See Figure 4.
NOTE: Whenever you start up the unit, the Total Hours are
displayed. The Total Hours will automatically reset to 0 after
999.9.
1. Press MODE for less than 1 second to display the Trip
Hours.
2. Press RESET for greater than 3 seconds to reset the
Trip Hours to 0.
3. Press MODE for less than 1 second to display the Clock
(see Set the Clock section).
4. Press MODE for less than 1 second to return to Total
Hours.
16
Set the Clock
See Figure 5.
1. Press MODE for greater than 3 seconds.
2. Press SCROLL to adjust the hours.
3. Press RESET to adjust the minutes.
4. Press MODE for less than 1 second to save the setting.
Maintenance Display Modes
See Figure 6,
To view the hours spent on each maintenance task:
1. Press and release SCROLL to select a maintenance
task. The FIGURE at the right shows the number of
hours since the oil was last changed.
To reset the hours to "0" after completing service:
1. Select a maintenance task by pressing and releasing
SCROLL.
2. Press RESET for greater than 3 seconds.
NOTE: RESET must be pressed within 10 seconds, other-
wise the display will return to the Total Time Mode.
NOTE: If the scheduled service time is exceeded by 3
hours, the system will AUTO RESET to "0".