Haier HWE15XCR-L User & Care Manual page 20

STARTING THE AIR CONDITIONER cont.
1. Carefully remove the clear plastic
2. Press POWER once to turn on the air conditioner.
NOTE: When the air conditioner is rst plugged in, the LED display will show "88" for 3 seconds.
After the air conditioner is turned on for the rst time, the display will show the
temperature
show ENERGY SAVE.
To switch between
seconds.
NOTE: To switch the temperature display between
conditioner must be plugged in, and turned on. The change cannot be done using the
remote control.
3. Select Mode. Refer to "Mode."
4. Select Speed. Refer to "Speed."
5. Set Timer. Refer to "Temp/Time"
6. Reset the check reminder. Refer to
MODE
1. Press mode until you see the indicator light come on next to the desired setting.
2. Choose Energy Save, Cool or Dehum.
FAN - Only the fan runs. Press SPEED to select High, Med or Low fan speed. The display shows
the current room temperature.
NOTE:
ENERGY SAVE - In this mode the fan runs only when cooling is needed. The fan will run for
3 minutes after the compressor shuts
minutes at 10 minute intervals until the temperature in the room is above the
set temperature. The compressor then turns back on.
COOL - Cools the room. Press SPEED to select High,Med , Low or Auto Cool fan speed. Press
the TEMP/TIME up or down arrow button to adjust the temperature. The fan will run
continuously in cool mode.
DEHUM - Aids in removing humidity from the room. Dehum mode cannot be used to cool the
room.
NOTE: In Dehum mode, when the set temperature is close to the ambient temperature,
the compressor may stop and the fan will run in low speed only.
PAGE 18
from the control panel.
and the fan is automatically set to Low speed and the Mode indicator will
and °C,press UP and DOWN buttons simultaneously and hold for 3
rature cannot be set.
USING YOUR AIR CONDITIONER
renheit and
Reset"
The fan then cycles on for 1 or 2
the air