Oven Light; Storage Drawer; Oven Bottom; Electrical Connection - Maytag 8113P299-60 User Manual

OVEN LIGHT

CAUTION:
➢ Disconnect power to range
before replacing light bulb.
➢ Use a dry potholder to prevent
possible harm to hands when
replacing bulb.
➢ Be sure bulb is cool before
touching bulb.
➢ Do not touch hot bulb with a
damp cloth as this may cause
the bulb to break.
BULB COVER
WIRE
RETAINER
TO REPLACE OVEN LIGHT BULB:
1. When oven is cool, hold bulb cover
in place, then slide wire retainer off
cover. NOTE: Bulb cover will fall if
not held in place while removing
wire retainer.
2. Remove bulb cover and light bulb.
3. Replace with a 40-watt appliance
bulb.
4. Replace bulb cover and secure with
wire retainer.
5. Reconnect power to range. Reset
clock.

STORAGE DRAWER

(Select models)
CAUTION:
➢ Do not store plastic, paper prod-
ucts, food or flammable materials
in this drawer. The drawer may
become too warm for these items
when the oven is in use.
The storage drawer can be removed to
allow you to clean under the range.
TO REMOVE:
1. Empty drawer and pull out to the first
stop position.
2. Lift up the front of the drawer.
3. Pull out to second stop position.
4. Grasp sides and lift drawer up and
out.
TO REPLACE:
1. Fit the ends of the drawer glides into
the rails in the range.
2. Lift up front of drawer and gently
push in to the first stop position.
3. Lift drawer up again and push until
drawer is closed.

OVEN BOTTOM

Protect oven bottom against spillovers,
especially acidic or sugary spills, as
they may discolor the porcelain enamel.
Use the correct pan size to avoid
spillovers and boilovers. Never place
utensils or foil directly on the oven
bottom.
The oven bottom may be removed for
easier cleaning.
TO REMOVE:
When cool, re-
move the oven
racks. Slide the
2
two catches, lo-
cated at each
rear corner of the
oven bottom, to-
ward the front of the oven.
Lift the rear edge of the oven bottom
slightly, then slide it back until the front
edge of the oven bottom clears the
oven front frame. Remove oven bottom
from oven.
TO REPLACE:
Fit the front edge of the oven bottom
into the oven-front frame. Lower the
rear of the oven bottom and slide the
two catches back to lock the oven bot-
tom in place.
ELECTRICAL
CONNECTION
Appliances which require electrical
power are equipped with a three-
prong grounding plug which must be
plugged directly into a properly ground-
ed three-hole 120 volt electrical outlet.
Always disconnect power to appliance
before servicing.
The three-prong
grounding
offers protection
against shock haz-
ards. Do not cut or
remove the third
grounding prong
from the power cord plug.
If an ungrounded, two-hole or other
type electrical outlet is encountered, it
is the personal responsibility of the
appliance owner to have the outlet
replaced with a properly grounded
three-hole electrical outlet.
REMOVAL OF
GAS APPLIANCE
Gas appliance connectors used to connect
this appliance to the gas supply are not
designed for continuous movement.
Once installed, DO NOT repeatedly
1
move this gas appliance for cleaning
or to relocate. If this appliance has to
be moved and/or removed for servic-
3
ing, follow the procedure described in
the installation instructions. For infor-
mation contact Maytag Customer
Service at 1-800-688-9900.
To prevent range from accidently tip-
ping, range must be secured to floor by
sliding the rear leveling leg into the anti-
tip bracket.
plug
16