Ipsec - Panasonic BB-HCS301A Troubleshooting Manual

Troubleshooting

IPsec

Problem
This product
cannot be
accessed in
transport mode.
This product
cannot be
accessed in
tunnel mode.
20
• IPsec policy settings are restricted.
Decrease the number of computers connected
simultaneously, and wait for a while, or shorten the lifetime in
the PC's IPsec settings.
• IPsec settings have not been set on your PC.
Set IPsec settings on your PC. See the Panasonic support
website (http://panasonic.net/pcc/support/netwkcam/)
for how to do this.
• The pre-shared key is not set correctly.
Set the same pre-shared key for this product and your PC
(see page 48 of Operating Instructions on the Setup CD-
ROM).
• On the VPN router within the network, tunnel mode has been
set.
Transport mode and tunnel mode can not be used at the
same time. Cancel the PC's IPsec settings, and
communicate using tunnel mode.
• Either PC's SA
*1
Disable the PC's IPsec settings, and enable it again.
• The pre-shared key is not set correctly.
Set the same pre-shared key for this product and the VPN
router (see page 51 of Operating Instructions on the Setup
CD-ROM).
• The VPN router is not set correctly.
Set the IKE and IPsec policy on the VPN router correctly (see
page 51, page 53, or page 54 of Operating Instructions on
the Setup CD-ROM).
• Either VPN router's SA
Restart the VPN router and this product.
Cause and Remedy
or SA of this product is not established.
or SA of this product is not established.
*1