Panasonic DP-8020E Operating Instructions Manual page 56

■ General Settings (For Key Operator) (Continued)
No.
23
24
25
26
27
28
29
30
31
33
34
∗
NOTE
∗
∗
56
Downloaded From ManualsPrinter.com Manuals
Function
Modes
DNS SERVER ADDR. ∗
2
MAC ADDRESS
HARD DISK FORMAT ∗
4
HARD DISK ERR CHK ∗
4
ABBR GROUP ID
COMMUNITY NAME(1) ∗
5
COMMUNITY NAME(2) ∗
5
DEVICE NAME ∗
5
DEVICE LOCATION ∗
5
USER AUTH ∗
6
AUTH DOMAIN
4 Available only when the optional Hard Disk Drive Unit is installed.
5 When Parameters No. 28 to 31 are set, cycle the power by turning the Power Switch on the Right Side of the
machine OFF and ON.
6 About the User Authentication, See Operating Instructions "For User Authentication".
Function
Selects whether to enable the DNS Server, and 2:VALID
sets its settings for Internet Fax/Email Function.
1:INVALID
2:VALID
<Sub-Function>
1:HOST NAME / 2:DOMAIN NAME /
3:PRI. DNS SERVER (IP ADDRESS1) /
4:SEC. DNS SERVER (IP ADDRESS2)
Indicates the MAC address.
Formats the hard disk.
PRESS SET TO START
Selects the provision for the hard disk error check.
PRESS SET TO START
Inputs the Group ID for the address book.
0-99
Selects whether to change the Community
Name(1) SNMP.
Enable read only
Selects whether to change the Community
Name(2) SNMP.
Enable read/write
Inputs the device name when required.
(For Status Monitor/EtherTalk Machine Name)
Inputs the device location when required.
(For Status Monitor)
Set the User Authentication Mode.
COPY
1:INVALID / 2:VALID
FAX
1:INVALID / 2:VALID
PRINTER
1:INVALID / 2:VALID
SCANNER
1:INVALID / 2:VALID
Inputs the Authentication Domain Name
Domain Name: Up to 15 characters.
DNS Domain Name: Up to 60 characters.
Initial
Setting
0
public
public
INVALID
INVALID
INVALID
INVALID