Access Point Mode - TP-Link TL-WR810N User Manual

necessary to change the wireless channel unless you notice interference problems with
another nearby access point.
 Disable Security - The wireless security function can be enabled or disabled. If
disabled, the wireless stations will be able to connect the Router without encryption. It is
recommended strongly that you choose one of following options to enable security.
 WPA-PSK/WPA2-PSK - Select WPA based on pre-shared passphrase.
PSK Password - You can enter ASCII or Hexadecimal characters.

For ASCII, the key can be made up of any numbers 0 to 9 and any letters A to Z, the
length should be between 8 and 63 characters.
For Hexadecimal, the key can be made up of any numbers 0 to 9 and letters A to F,
the length should be between 8 and 64 characters.
Please also note the key is case sensitive, this means that upper and lower case
keys will affect the outcome. It would also be a good idea to write down the key and
all related wireless security settings.
 No Change - If you chose this option, wireless security configuration will not change!
These settings are only for basic wireless parameters. For advanced settings, please refer to
4.7 Wireless.
4. The Finish page is shown as Figure 3-12. Click the Finish button to make your wireless
configuration take effect and finish the Quick Setup.

3.2.2 Access Point Mode

When you set the operation mode switch to Router/AP, take the following steps:
1. Select Access Point mode and click Next.
2. The Wireless Setting page will appear as shown in Figure 3-13.
TL-WR810N 300Mbps WiFi Pocket Router/AP/TV Adapter/Repeater
Figure 3-12 Quick Setup - Finish
- 17 -